دوستانی که زبانشون خوبه میتونن این متن رو ترجمه کنن؟؟در مورد hdr و وفعال کردن daynamic contrast هستش
When calibrating SDR, LG recommends using a test pattern generator
set to output 18% area (or smaller) greyscale patterns with a black
background
• When calibrating HDR, LG recommends using a test pattern generator
set to output 10% area (or smaller) greyscale patterns with a black
background
• During HDR calibration, disable ‘Active HDR*’ (self generated dynamic
tone mapping) by setting the ‘Dynamic Contrast’ setting in the Expert
Picture Mode Settings to ‘Off’
• After calibration, for best results, re-enable ‘Active HDR*’ by setting the
‘Dynamic Contrast’ setting in the Expert Picture Mode Settings to ‘Low’
• For Dolby Vision calibration, CalMan 2017 must be used, along with a
test pattern generator compatible with Dolby Vision test patterns (e.g.
Murideo Six-G)
• The ‘Edge Enhancer’ setting in the Expert Picture Mode Settings does
not increase sharpness; the default ‘On’ setting is a bypass function, and
is therefore recommended
• 20 HDR Calibration adjustment points have been provided for 540nit
content, 1,000nit content, and 4,000nit content, shown in the table
below. A test pattern generator should be set to output a grey patch at
the appropriated Code Value for each adjustment point. If using
CalMan, launch Levels Editor, and create a new set of levels using the
percentages in the table below, then select this range for the greyscale
adjustment in the settings tab of the HDR workflow.